All FAQs » Belkin Equipment Forum FAQ » 4.0 Troubleshooting » 13631
Restoring a Belkin router to the factory default state. (#13631)
•Unplug all LAN cables from the router.
•Unplug the router power cord connector from the back of the device.
•Using a paper clip or something similar that will fit into the reset hole, press continue to hold the reset button, then carefully reinsert the power cord, making sure not to release the reset button in the process.
•Continue to hold the reset button in for at least 15 seconds after inserting the power cord, then release it. After about 10-25 seconds the router will boot and it will be set back to the original factory default settings.
By default the password on the router is left blank, and the default IP address is 192.168.2.1
Resetting the 4-Port Router to factory default:
•With the router powered on, press and hold the reset button for exactly seven seconds, this will restore the router to factory default.
•This also applies to: F5D5230-4 4-Port Cable/DSL Gateway Router, F5D6230-3 Wireless Cable/DSL Gateway Router (11Mbps), F5D6231-4 802.11b Wireless Cable/DSL Gateway Router, and F5D7230-4 Wireless G Router Resolution.
•Note: By default the password on the router is left blank, and the default IP address is 192.168.2.1
•SOURCE: »www.belkin.com/support/article/?···scid=220
Friday, May 28, 2010
Friday, May 21, 2010
New blog for "gem baysan"
this is a blog that i will add to later when i have more content. i will add more when i have things to add which i dont at this time.
Subscribe to:
Posts (Atom)